Reply To: Carrom Board

I have an approach that would probably be best described via a diagram, so see the image attached.

Instead of thinking it as 4 narrow frame pieces (like a picture frame), think of it 8 components: 4 corner pieces (red in the image) that would be made square and dimensioned to encompass the frame width plus the hole that creates the radius of that corner. You’ll cut those four squares then drill or carve out one corner (blue in the image). Then you’ll have 4 narrower pieces that will form the main part of the frame (green in the image). Depending on how big that radius is, you could even get really fancy and take one large square piece that’s exactly sized to later create the four smaller squares, find the exact center, and drill out the center with the proper bit. Then cut the squares apart.