Reply To: Building a sawbench

Welcome! Forums General Woodworking Discussions Building a sawbench Reply To: Building a sawbench

David Gill

Hi George

What I did was to place a piece of MDF board on top of my work bench, then using a spirit level and packing I made sure the board was horizontal in both directions. I then sat the saw bench on top of the board and again using packing under the four legs I made sure the top of the bench was horizontal in both directions . It was just a case then of using a block of the required height and marking the cut lines around the bottom of each leg. Saw to these lines and the bench will sit on a flat floor without rocking.


Wigan, Lancs. England :