Hall Table
Welcome! / Forums / General Woodworking Discussions / Projects / Hall Table
- This topic has 10 replies, 4 voices, and was last updated 5 years, 6 months ago by Sven-Olof Jansson.
-
AuthorPosts
-
10 October 2018 at 11:51 am #552621
Hej,
Please, would you tell what joints you used for the front rails and the small vertical divider? I experienced a major failure using twin and triple tenons and mortices for the lower rail, and am looking for alternatives to use in the future; most likely stopped dovetails (more or less sliding)./Sven-Olof
- This reply was modified 5 years, 6 months ago by Sven-Olof Jansson. Reason: typos
Attachments:
You must be logged in to view attached files.Sven
Attached is a picture that will hopefully explain the joints.
The leg rails are simple mortise and tenon.
The divider I s jointed with through tenons
The top front rail has inset dovetails
The front bottom rail has a mortise and tenon open on the rear of the leg
The guide rails are mortised as well.Attachments:
You must be logged in to view attached files.Sven
Attached is a picture that will hopefully explain the joints.
The leg rails are simple mortise and tenon.
The divider Is jointed with through tenons
The top front rail has inset dovetails
The front bottom rail is mortise and tenon, open on the rear of the leg
The guide rails are mortised as well.Hope this helps.
Attachments:
You must be logged in to view attached files. -
AuthorPosts
- You must be logged in to reply to this topic.