Paul making a handsaw handle

Welcome! › Forums › General Woodworking Discussions › Tools and Tool Maintenance/Restoration › Paul making a handsaw handle

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 18 July 2020 at 6:14 am #670191
    RANDY REECE
    Participant

    I can’t remember if I saw a blog or video made by Paul wherein he rehab’d a handsaw and then made a new handle for it. I would like to review it again but can’t find it. Anyone know where it is?

    I have some saw handles that need replacing.

    Thanks

    R. Reece

    18 July 2020 at 7:31 am #670195
    Larry Geib
    Participant

    I remember Paul showing how to reshape handles, but I haven’t seen him do a new handle.

    Same general procedures as a tote, except the hardest part is getting the plate slot centered..

    And make sure the grain runs lengthwise though the skinny bits.

    Here are the posts tagged “saw handles”

    https://paulsellers.com/tag/saw-handles/

    There might be enough there to get you going .

    18 July 2020 at 2:14 pm #670231
    Jose Garcia
    Participant

    I believe that Badaxe tools requests a measurement of your hand when you order your saw. They make them in three sizes.
    I’m sure if you talk with them they will be able to fit your needs.
    They are expensive but very high quality saws.

    18 July 2020 at 5:36 pm #670254
    Larry Geib
    Participant

    Bad axe’s owner Mark Harrell’s wife died this week, so be understanding for a while while he and his two teenage kids take some time to heal.
    He says he is still taking orders, but the pace will be reduced for a while.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.