Welcome! Forums Project Series Joiner’s Toolbox Project Silly mistake on the base trim

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #125424
    bonius
    Participant

    Pay attention to the orientation of your dovetails when making the trim. Don’t do what I did! 🙂

    I had to start the base trim over, but it turned out OK in the end.

    Attachments:
    #125427
    Joe
    Participant

    Lol. Looking good so far, I had to redo one piece of trim because i cut on the wrong side of the line.

    Joe in California

    #125429
    rotaryw
    Participant

    Curiously enough I made the same error last evening, what is diabolic is that I repeated the same error twice… therefore I marked both pieces with the writing “dummy” and left it on the bench for future memory !!!

    #127102
    Sandy
    Participant

    I’ve done that so many times it’s crazy. I made some mistakes on my lower trim. Measured for tge bevel on different edges. I didn’t see it till I glued it on. Ya can’t see it unless you really look hard. The lessons we learn! 🙂

    Insanity: doing the same thing over and over again and expecting different results.

    Albert Einstein

    #127103
    Matt McGrane
    Participant

    Chalk one up for experience. Just today I cut a miter in the wrong direction and had to remake the part. It was the first thing I did this morning. I guess I was too eager and not paying enough attention.

    Matt, Northern California - Started a blog in 2016: http://tinyshopww.blogspot.com/

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.