@sdbeggs
Forum Replies Created
-
Posts
-
A cleat supported by toggle at 8 inch intervals could support 200 lbs assuming a 36 inch shelf but that is not been personally tested, it’s just an estimate. Take it with a grain of salt.
Another point is I would never trust a load where a gap exists as you describe. The gap would put a tear down stress on the wall board at shelf attach point. I’m not sure 8m using the correct terminology I hope it’s understood.
400 lbs? I personally would not attempt based on the restrictions you cite.
I would build a box and set it in. Keep the sides 1/8 inch below the top of the granite. I did this for a piece of marble where I built a coffee table
Did you not see the April 1st at end?
I’m rather new, but I had the same thing happen, I changed from a 13 tpi to 6 saw and got much better results.
