Reply To: Knots
Welcome! / Forums / General Woodworking Discussions / Wood and Wood Preparation / Knots / Reply To: Knots
Hi Dave, that’s good advice. Thank you
just so I understand you correctly, you’re saying rather than trying to plane across the full diameter of the knot I should go over it in little chunks? So a sliver of one side, then a bit more till I’ve covered everything?
Yes, will need to sharpen up the irons again – I’m sure that will help too.
I don’t understand what the glue will do to the area. Do I just slap a bit of glue on top? Won’t I just plane that off again and be where I started out before?
I tried going across them with a chisel, but that just looked messy too (probably needs sharpening too).
thank you