Reply To: Finally putting aside discouragement… A little workbench project help?
Welcome! / Forums / General Woodworking Discussions / Projects / Finally putting aside discouragement… A little workbench project help? / Reply To: Finally putting aside discouragement… A little workbench project help?
Do you have a pair of winding sticks? I would check to see if each top is twist free with them. Make this your face side. Mark it.
Check with a square to make sure that one side is square to your face side. This will be your face edge. Mark it.
Check the other two sides for squareness, registering off of either the face or the edge side only. You will have to do this for each top.
If Both tops are twist free and square then your problem is with the legs.
With both tops being twist free and square, you can lay your legs on the top to make sure they are twist free.
You can measure corner to cornet to make sure they are square.
Measure height and width on both top and bottom.
If everything measure correctly it has to be the aprons that are warped.