Reply To: Need advice on joint(s) to use to make a 9-foot bar top
Welcome! / Forums / General Woodworking Discussions / Woodworking Methods and Techniques / Need advice on joint(s) to use to make a 9-foot bar top / Reply To: Need advice on joint(s) to use to make a 9-foot bar top
Bryan,
I have a similar project where I want to laminate pieces of wood that are shorter than the end result. I see this is an old post so maybe it’s a long shot, but asking anyway.
Did you end up making your bar top and if so, what was your approach? The issue I have is that if the boards aren’t exactly equal width, I can’t glue then up in one go as there will be space between two parallel boards near the butt joints. My current approach is to glue them one layer at the time, planing the new edge straight between sessions. For a tabletop I want to make I’d need 10 sessions at least.
What was your approach?
-
This reply was modified 9 months ago by
Mic van Reijen.
-
This reply was modified 9 months ago by
Mic van Reijen.