Reply To: Reply To: Card scraper finish
Welcome! / Forums / General Woodworking Discussions / Card scraper finish / Reply To: Reply To: Card scraper finish
28 November 2012 at 1:11 pm
#3942
Thanks Ken. That was a great video. Helped a lot.
Thanks Gary. Great explanation on consolidation. The difference on a Stanley #80 (sorry, I didn’t make it clear that was what I was trying to use) is that the blade already has a bevel cut at 45 degrees (I believe). Are you attempting to roll the edge over at the point/tip of that bevel? Do you consolidate the blade in the same way or do you run it along the bevel?
Thanks
Jon