Reply To: Workbench Progress
Welcome! / Forums / General Woodworking Discussions / Workbench Progress / Reply To: Workbench Progress
20 December 2012 at 9:08 pm
#5373
I don’t want to hijack this thread, but I have a question. I am busy building my bench and I already glued up the aprons. They have to be planed nice and straight and twist free though. But now I am working on the lamination of the top. I noticed that a couple of the beams (actually all but one) are pretty twisted. Now I think this question is rhetorical but should I get them twist free before gluing? If so how about doing that. Normally I would go from high corner to high corner but these are around 60 inches long. Just doing the ends might leave a large bow. Any advice? Thank you.