Reply To: Old Stanley No 4 plane blade replacements
…into the plane but as Harvey stated the mouth needed opening up the width of the mouth before opening up was 0.192″as the new blade was 0.023″ thicker i figured…
…into the plane but as Harvey stated the mouth needed opening up the width of the mouth before opening up was 0.192″as the new blade was 0.023″ thicker i figured…
…open the joint. An upwards for will not open the joint. But a downwards force (in the case of the bottom of the bathroom cabinet) would act to open up…
…disengaging when backing off (opening) the vise. Sometimes I want the vice to screw open (and then closed) rather than having to pull it open and then push it closed….
…Jorgensen 41012 Jaw Width 10″ Opening 12″ Eclipse 10″ Jaw Width 10″ Opening 14-7/8″ York (Lee Valley, Made in Czech) Jaw Width 10.5″ Opening 15″ I am inclined to think…
Hi Brian, they both look pretty nice to me. But if you want an opinion, for a coffee table, I think an open structure would be better. However, that can…
…remedy this I could recess the hinges even deeper but then they would sit below the wood. Maybe I need to find a better hinge source? [attachment file=309357] [attachment file=309358]…
…well shaped mouth, though. Make sure the iron is in top form so you have something to test your filing to. Go slow and test often. Cast iron files quickly….
…to research it by conducting internet searches, reading magazine articles, etc., there were tons of differing opinions and many contradicted each other. Consensus among the traditionalists claim that bevel chisels…
…dead glue. Third, I didn’t test it for stickiness. I put a small drop of hot glue onto my thumb and then press my index finger into it. Opening and…
…and tested, I’ll order a beam, do some test cuts, and see what the quality is like. Hopefully it’ll be clear and stable enough for furniture projects. I’ll post again…