Not really a project more practice
Just got a 3/4″ skewed wooden rebate plane off of ebay. I trued up sole flattened and honed iron. I then ran a 1/2″ marking gauge line along 2′ piece…
Just got a 3/4″ skewed wooden rebate plane off of ebay. I trued up sole flattened and honed iron. I then ran a 1/2″ marking gauge line along 2′ piece…
…be substituted without using spreader straps? Q: I would like to know if when folded, does the platform flop around? I am in the USA (Michigan), and importing these hinges…
…one piece and 7/16 on another, and exactly 3/8 on another, it would look fine in most cases. You could built to exact dimensions, e.g., outer dimensions of a drawer,…
…at least, glue-up has been uneventful and thanks to Paul’s method I had plenty of time. Hopefully, the front and back panels will go as easily. [attachment file=544944] [attachment file=544945]…
…from it. The only draw back that I’ve found so far is that finding wide widths is difficult, as it’s a fairly slim tree compared to many furniture woods. http://www.wood-database.com/lumber-identification/hardwoods/red-alder/…
…This can happen when the top divider is dovetailed into the legs and the dovetailing is deeper on one side! I know, it’s endless…..patience! One trick I’ve used to get…
…use a “frame and panel” type of construction. For example, if you want a 15″ wide (tall) headboard, have a 9 3/4″ panel (or maybe two panels separated by a…
Been there, tried it (with a 1.8mm thick HSS blade). It would have take ages, even on a rough more grinding than sharpening stone, so that abrasion can take place…
…extend the blade too far you will start to get chatter. The ‘L’ shaped holder offers better support for complex shapes. I have also seen photos of the ‘L’ shaped…
…Most of the benches I see, including Paul’s, show overhangs in the 1+’ range, though most benches are longer than your build. <edit> Paul specifies a 9″ overhang here: https://paulsellers.com/2012/06/making-the-workbench-11/…