Abandoning a glue-up
…crack. (That is, in some bizarrely profound way, appropriate for a meditation stool.) My question is whether this is a correct understanding of PVA glue? If so, my slow meandering…
…crack. (That is, in some bizarrely profound way, appropriate for a meditation stool.) My question is whether this is a correct understanding of PVA glue? If so, my slow meandering…
Teach your wife to chop mortises. Addict her to the art. Transform her into a noisemaker herself. @lorenzojose , since a hammer blow is a chirp or delta function and…
[quote quote=6674]Here are some pictures of my test today. The round-one is the final version without the cutter fitted. It works fine. [/quote] Just wanted to round-up my test with…
…a fellow on this site http://www.ukworkshop.co.uk/forums/accessory-blades-for-the-veritas-small-plow-t61384.html Another fellow states his Record 050 cutters ( not 050C) are 74 mm long. They have a notch. So if your adjuster will open…
I found that the corrosion was a lot worse on the back of the Iron than on the front , so I ground off the bevel and ground a new…
…building supply lumber places (like STOCK Building supply) sell a doug-fir wall stud that is more like a 3×4 (probably 2.5″x3.5″) which would be ideal for a bench top, but…
I have a half round and a round that I got from Lee Valley: http://www.leevalley.com/en/Wood/page.aspx?cat=1&p=42524 They are reasonably priced and work very well. I’d like to go for the Auriou…
…ends of ‘bread-board’ timber). Then there is the option of running a decorative trim round the whole table with mitred corners……probably the least favourite option – but it’s your table……
I had two types of mallets on my bench – the hammer type Paul uses and a turned round carving mallet – and I used both quite a bit. It…
…remove the burr. I think it now takes me well under five minutes to sharpen a chisel or plane blade. FWIW, I still prefer water stones for sharpening knives however….