Reply To: Advice on vises
…record 52.5 with 9″ wide jaws and a 13″ opening cleaned up a treat.plus a paramo 152 (never used) with 10″ wide x 12″ opening. For………….99pence!!! Beat that J UK…
…record 52.5 with 9″ wide jaws and a 13″ opening cleaned up a treat.plus a paramo 152 (never used) with 10″ wide x 12″ opening. For………….99pence!!! Beat that J UK…
I’m thinking of putting a vacuum cleaner port in the wall between my woodshop and garage, then open the outer garage door to vent it out. Another thought would be…
Matt, the big vice has a bigger face and opening. I know the specs only indicate it’s a couple inches bigger opening but there has been numerous occasions when that…
…judiciously is all that is required. As Dave says, any removal of material in the sole will open up the mouth, which if you will use the plane as a…
…made my router base, my suggestion is to just cut an opening in your base with a coping saw, perhaps backing it with some scrap material if it is particularly…
…at least, glue-up has been uneventful and thanks to Paul’s method I had plenty of time. Hopefully, the front and back panels will go as easily. [attachment file=544944] [attachment file=544945]…
Thanks Craig and Larry, So some paraffin candle on the thread should do it π Haven’t got any lithium grease at home. I haven’t yet received that brace, hopefully coming…
Hi everyone I ordered a vice from eBay, had a terrible experience because it had not arrived even after three weeks. Anyway, it was an 8″ vice that opened to…
I’m building a small side table with a drawer and cupboard, the sides of which splay out at a 5deg angle. I’m committed to the splay but it’s causing a…
…vertical it should open like any other door. The hinges should be fixed normally staright on the edge of the panel and on the face of the door. If you…