Reply To: Repair to benchleg
Welcome! / Forums / General Woodworking Discussions / Wood and Wood Preparation / Repair to benchleg / Reply To: Repair to benchleg
If all else fails Franko, you could always introduce a few long 2 1/2 inch screws to the situation, glue, clamp tight and then drive some screws in to make sure it stays put. Its not likely to create any issues once its all together. It is a workbench after all. If it were a piece of furniture then I’d seriously consider replacing the leg but…
My workbench had all the problems because it was built right from the very start of my hand tool learning. It ended up twisted, not square, the top laminated with no concern for grain direction, etc. I didn’t even trim the ends of the top. But it works, and its now flat and square once I understood what flat and square meant 🙂