Reply To: Off cuts and scraps, what do YOU do with them?

I may have to copy that jig 🙂 Is there any taper to the jig, or would you add a taper to the dovetails with a sanding block?
I made a set of bookshelves, loose-ish stopped sliding dovetails, no taper on a PC clone dovetail jig (power tools phase of my life 🙂 ), I also had cupped sides, and when I cut the grooves and did the dry fit, I clamped braces across the sides to flatten the cup out, assembled the shelves, then released the braces. The sides cupped again and locked the shelves solidly in place.