Reply To: How would you repair this bad blow out of wood during panel glue up?
Welcome! / Forums / General Woodworking Discussions / Woodworking Methods and Techniques / How would you repair this bad blow out of wood during panel glue up? / Reply To: How would you repair this bad blow out of wood during panel glue up?
Dear All,
Just wanted to close the loop on this. Remove the clamps and tape and the surface looked significan’tly better and more flat. Used my hand plane for a few swipes and cleaned it up. It is much better. Not as good as if I hadn’t broken it. Given the location (lower cabinet in the back) and that there will be towels in there and that it is for my family, it really won’t be seen. Even if it is, I have a story of how not being sensitive when working (or assembling) can cause problems that can otherwise be avoided. Thank you for the suggestions as they helped.
Sincerely,
Joe
[attachment file=”725649″]
[attachment file=”725650″]
[attachment file=”725651″]
- This reply was modified 2 years, 8 months ago by joeleonetti.
- This reply was modified 2 years, 8 months ago by joeleonetti.