First Project – Shooting Board

Welcome! Forums General Woodworking Discussions Projects First Project – Shooting Board

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #746684
    George Castillo

    My first shooting board. So stoked to be able to have clean end grain and not remnants of a bad cross cut saw when I want to mark things. Ready to start some joinery!

    Any recommendations on what to treat it with, particularly to prevent checking of the end grain pieces or wedges? There’s also a lot of marks on rhe top from the router plane.

    Matt McGrane

    Looks good. I’m pretty sure I left mine unfinished. It’s been in service several years now. But it has gone out of square on me a couple of times. When that happens, I need to plane the reference surface of the wedge to get it square again. Remember to check yours for square once in a while.

    Matt, Northern California - Started a blog in 2016:

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.