Welcome! Forums Project Series Tool Chest Little toolchest

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #131679
    jude
    Participant

    Here’s a little toolchest I just made. It is basically a 1/2 size version of the toolchest project.

    The sides are 3/8″, the drawer sides are 1/4″ etc. etc.

    There wasn’t any grand plan for this toolchest, I just wanted to make the project to learn the joinery, but I didn’t want to buy a load of wood. So, I made it small and used leftover wood.

    judekenny.wordpress.com

    Near Chicago, USA

    Attachments:
    #131681
    jude
    Participant

    This little chest has all the same joinery, just scaled down.

    The carcase joinery was a bit rough, but planed down nice.

    judekenny.wordpress.com

    Near Chicago, USA

    Attachments:
    #131686
    jude
    Participant

    The drawers were finicky too. This all was a lot smaller than I was used to.

    I also made some drawer pulls out of some saw nuts 😉

    This project really tested my patience but I’m happy I did it.

    judekenny.wordpress.com

    Near Chicago, USA

    Attachments:
    #131692
    Joe Kaiser
    Participant

    Nice! I am thinking now this could make a nice jewlerybox. I may have to do that sometime

    Seattle, WA

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.