Workbench build started

Welcome! Forums General Woodworking Discussions Projects Workbench build started

Tagged: 

Viewing 7 posts - 16 through 22 (of 22 total)
  • Author
    Posts
  • #122139
    mike forbes
    Participant

    Looking great! Coming along very nicely.

    Boulder,CO http://mikeofallthings.com

    #122140
    Alien8
    Participant

    Nice work !
    Just remember not to rush it now…

    Diego

    #122192
    Marilyn Moreno
    Participant

    @alien8, you are so right. Almost there, but not rushing it… This is why parts are still clamped together.
    Next step is to screw the aprons to the legs and then run the square lines of bench top to aprons.
    Then I’ll finally plane the top to those square lines.

    Marilyn - Lehigh Valley, Eastern Pennsylvania - USA

    #123087
    Marilyn Moreno
    Participant

    Had time over the Christmas Holiday to complete the workbench. The last of the pictures attached.
    The workbench is 60″ x 28.5″, 37″ high. Main Top is 14.5″ made of Pine (whitewood) Aprons are Douglas Fir (horrible knots that I had to fill with CA glue).
    The last step is to apply a finish to the tops and aprons. Legs were already finished.
    I’ll need to pick up a vise and install it: That will be another adventure.
    I was so thrilled that I began using it without the finish. I’m using clamps to hold down my work pieces.

    Thanks to all for the suggestions and encouragement throughout this build.

    P.S. Happy New Year to all

    Marilyn

    Marilyn - Lehigh Valley, Eastern Pennsylvania - USA

    #123090
    Dave
    Participant

    Nicely done Marilyn.

    -Canada

    #123102
    Greg Merritt
    Participant

    Looks really good. Well done and congratulations. Now all you have to do is start scarring it up while building you next project. 🙂

    http://hillbillydaiku.com

    #123110
    mike forbes
    Participant

    Great job! Now onto the good stuff!

    Boulder,CO http://mikeofallthings.com

Viewing 7 posts - 16 through 22 (of 22 total)
  • You must be logged in to reply to this topic.