Forum Replies Created
-
AuthorPosts
-
23 January 2023 at 3:11 pm #788714
It shouldn’t be the case.
What kind of curve do you have in the back?
Also, are you doing this on sand paper? If so and if you kept your larger chisel to the end, perhaps you should change your paper.Final question: are all your chisels of the same making?
28 March 2021 at 6:51 pm #707094Thanks for the advice!
So I’m no professional, but at my first attempt, I knew I did something wrong somewhere. Hope I’m not the only one this happened.
[attachment file=”707095″]
Jokes apart, I did get a decent chisel box (still some glue needed to be removed here.
[attachment file=”707096″]
But I had a hard time to have a snug fit. I found them either loose or so small it broke
[attachment file=”707097″]
How do you guys check for fitness without breaking anything?
Regards
BlaiseAttachments:
You must be logged in to view attached files.10 March 2021 at 8:56 pm #704719Thx Colin,
For your question, it’s just that the project calls for 1/2″ thick stock for the sides and 3/8 for the bottom.
Assuming I can resaw straigt, I guess I could reuse the “thin” piece for the bottom.
I was mostly asking how people waste as less as possible.
Blaise
-
AuthorPosts