Forum Replies Created
-
AuthorPosts
-
27 August 2018 at 9:13 pm #550638
I allowed the bit to ‘do it’s thing’ on its own, then applied more pressure until my 17 stone body weight was pressing on it. The bit spins but doesn’t cut. I tried using the brace and bit in both the horizontal and vertical, same result. The two bits that work, no need for any pressure, they both fly the wood.I’ve compared the bits and noted the angles on the bits that are in good order. To me, they all look the same. Therefore, they should all cut the same. RHHHHHUUUUUUBBBBBAAARRRBBBB!!!
27 August 2018 at 9:04 pm #550634The snails are fine threads, so used in hardwoods. However, it did exactly the same in pine. The angle may be wrong but its similar to the one in the book and the video.
-
AuthorPosts