Forum Replies Created
-
AuthorPosts
-
Your right Derek,
I am building the Tom Fidgen Funeral Chair. I got the seat slats cut, seat frame fitted, finished the pieces then glued up and pinned the corners. It was perfectly square and flat. Today I was continuing work on the legs and seat back. I looked over at the seat and two days later it is higher on the left front by about 1/8 inch. We had a big rain yesterday and today the humidity was up about 85%. I though about planing it flat again, but decided that in a few days or next week it may well be flat again on its own.
Jimmy Brown
Canton, GAHey lute, I went with a 1″ thick well board. It works fine and I have been using my bench every day for about 2 months since I finished the build. I did that because I foolishly trusted my measurements would be correct and planed the well board I had laminated and it was 1/4″ too narrow. So to avoid the gap I just got a 1×8 and ripped and planed it to size. Now I just have to figure out what to do with that other well board, I’ll make something nice out of it, just don’t know what yet.
Your table looks great! Good work! Hope that helps.
jimmyb
-
AuthorPosts