Forum Replies Created
-
AuthorPosts
-
28 May 2020 at 11:50 pm #663281
Hi Mike, your reply was useful to me as i was in the same boat a gabe. So thanks for that.
I’ve sourced the screw and chip deflector that i was missing.
I cant see how the chip deflector works and having tried the 3/16 cutter secured with the screw im not getting successful results with it like i do with the 1/4″ cutter. Its tearing and the shaving is way too thick.
Even though I start with a fine set i think the cutter is flexing and digging deeper with it not being supported as well as the larger cutters with the sliding section clamping it for most of the cutter length
Would you happen to know if there is something that im missing here. I cant see if the chip deflector would help or how it fits. Any help would be appreciated.
Regards
Mark
21 March 2020 at 8:25 am #653917Did you make your joiners box John?
I can’t answer your question but wondered what you chose and how it turned out?
Regards
Mark
-
AuthorPosts