Forum Replies Created
-
AuthorPosts
-
20 December 2018 at 6:55 pm #554067
That’s the same thing I’ve noticed with mine Eric, at the smallest setting it gives a little too much set for my dovetail saws. I’ve heard they anvils are a little soft and tend to move some when squeezed too hard.
12 May 2018 at 4:13 pm #544931These were 3/4 inch chisels that I was using to cut mortises with. They’re definitely sharp and the backs are flat, but edges aren’t square. I haven’t checked them against a square to see how far out they are but it’s noticeable, most likely because one of them had been sharpened by someone else previously that had obviously used some sort of honing guide and put a micro-bevel on it. I previously owned a Veritas honing guide but sold it as I seemed to get better results freehand and didn’t have to take the time to set it up.
Anything I should look for with my work to tell whether or not the non-square edge is affecting anything?
-
AuthorPosts