Forum Replies Created
-
AuthorPosts
-
8 January 2023 at 12:31 pm #786213
ok , just had a look at the video, and Paul does what Ed suggest with the chisel ( KeepSake Box Video 2 6:55).
Thanks a lot Ed & Dean.
Best Regards,
V.
8 January 2023 at 12:21 pm #786212[postquote quote=786161]
i fully understand what to mean, for this reason i was expecting to plow ‘from both side’. it would need to have parralelality between faces to ensure results but i was applying the same concept as planning end grain : come from both side, don’t go over the edge from one side to the other.
I also expect that the end grain face of the wood would not be too visible inside the groove once made. so any discrepencies made visible by the planing direction overlap should be quite negligeable. Paul would most certainly says this is mostly wisfull thinking 😀
[postquote quote=786175]
Thank you so much for this insigth, i ll have a look at it again, that could be a decent training and a new jewel box for the wifey in the mean time 😀
7 January 2023 at 7:31 pm #786120Dear Ed,
Thank you so much for this detailed reply.
I’ll cut 7/10cm(2 and 1/2 ” to 3 and 1/4 “) wide of two slab glue end together edge to edge to get a representative length (slabs are around 40 cm wide/ 15 inch and 3/4) and give it a shot.
I see many opportunity to scr*w this pretty hard, but trainning on scrap sure is the way to go.
I intend to work with chestnut, any particular recommandation you would dare to add?
Thank you so much again.
I’ll post photo to track the mess 😀 (hopefully not :D)
Best Regards,
V.
-
AuthorPosts