Forum Replies Created
-
AuthorPosts
-
3 January 2018 at 2:56 pm #427209
the one i just bought was also pretty dirty and rusted so i started out by soaking them in Rockler Pitch & Resin Remover for about an hour then i hit them with steel wool 0000 and 150-220 grit sandpaper… everything cleaned up very nicely… i hope this helps
2 December 2017 at 11:04 pm #391795i just bought the stanley no. 50 and it was missing the cutter hold down screw.. i just went to the hardware store and pick up a bolt with a flat underside head on it and a wing nut and it works just fine… i was still unsure if i was still missing something since it was such an easy fix so i kept an eye out for the correct screw and bought it…. that was completely unnecessary… the sliding fence isn’t attached when using the smaller beading cutters so there is no restrictions as far as the size of the bolt head…
fyi the beading gauge is only used with the larger cutters so the sliding section is used and so the cutter hold down screw isn’t a factor… it took me some time to figure this out…
i love this little plane mine took some time to clean off the rust and re-sharpen but not it works great…
hope this helps… -
AuthorPosts