Reply To: Aldi Chisels
…that two of them are TINY, so unless you are into instrument building or some other small-scale work you are probably only getting two usable clamps. Jeff, my wife is…
…that two of them are TINY, so unless you are into instrument building or some other small-scale work you are probably only getting two usable clamps. Jeff, my wife is…
…thickness but so thin… So I had to compensate for that to get the baseline for the dovetails just right. After a few small boxes, I have a pretty good…
…for the life of me, get the scallops on the uprights and cross beam to fit snugly and flush. I even went so far as to use a set of…
…scalloped M&T but it looks quite tricky to get a perfect fit on the curved shoulder. The bottom line with a saw is whether it saws stuff and the joint…
Not to worry, the bench has it’s scars from day one already.. I’m considering to make an insert from some hard wood where the saw always runs next to the…
Sofa Table Gallery Welcome to the Sofa Table community gallery. You can watch Paul’s introduction to the project here. Here is Paul’s example… And now it’s over to you! Sofa Table…
…and I love it. I’m not a professional woodworker, but rather an amateur like many in this community. All my life I have been working with wood (scars from childhood…
I think the thickness should not be scaled to the same degree as length and width of pieces. I don’t know what it should be, but if you draw it…
…process is allowed to run determines the finished shade. This technique was common a hundred years ago, but I read somewhere that health and safety concerns when used on an…
…a 45° cut on both edges. Then a round bottom plane (as made in this project) is used to scallop the midsection, followed by the scraper and a light sanding….