Coffee Table: Episode 13
This is an extra-long episode where Paul shows how to glue up the final assembly. Be prepared to work quickly an do a rehearsal ahead of time. Also, be sure to label everything very clearly. You’ll see why…
This is an extra-long episode where Paul shows how to glue up the final assembly. Be prepared to work quickly an do a rehearsal ahead of time. Also, be sure to label everything very clearly. You’ll see why…
In this episode Paul shows how to glue up, or laminate, narrower boards to make up the top. This video will actually be helpful as a reference video for gluing up flat boards to make a wider surface, regardless of the project.
In this episode Paul shows how to add the divider to make the caddy have two sections. He does this by creating a small housing dado to house a small divider.
In this episode Paul shows how to make the stub tenons for the shelf. This episode concludes the mortise and tenons for this project. Next episode we will start on preparing the table top.
In this section Paul shows the joinery for the magazine shelf under the table. He then shows some alternative decorations for the ends of the tenon. This gives you a few different options for dressing up this feature of the table.
In this episode Paul shows how to lay out the joinery for the magazine shelf. This requires that the main frame of the table be clamped into it’s final position so that the measurements can be taken precisely.
In this episode Paul shows how to create small pocket mortises which will later be used to attach the table top. He also shows how to prepare each of the pieces and test the assembly so that you can layout the joinery for the magazine shelf.
In this episode you will be shown how to make a template for the shape of the aprons. Paul shows how to cut the shape of the apron in two ways. One, using a brace and bit and the stop cut method and two, using a coping saw and the stop cut method.
In this Episode Paul shows how to cut the single dovetails on the front of this caddy. He also shows how to finish off the double dovetail he began in the first episode.
More mortise and tenon! This project was designed so that you could achieve full mastery of the different kinds of mortise and tenon joint. This episode covers the through tenon. Paul shows how to carefully fit it and also how to round over the protruding tenon.