Forum Replies Created
-
AuthorPosts
-
22 March 2018 at 10:18 pm #505828
Hi Igor. I’m not sure if you are still looking but fastenal has alot of options. I am also not sure if they ship internationally or not but worth a check.
22 March 2018 at 2:26 pm #505514I have that crown saw. It’s a good quality cheap saw to start with and Paul has videos on straightening and tuning them up. I believe I used a 6 inch double extra slim taper file with one or two passes on each tooth and it works great. Not a bad saw to do get practice filing on either.
17 November 2017 at 3:35 am #369426Late reply but could be useful to someone. I find barkeepers friend works wonders on my DMT plates. It has oxalic acid in it which takes the rust off and seems to do a much better job than ajax/comet. I only use it when they start to look really bad or neglected. I haven’t noticed any damage to the plate or diamonds from using it but I’d say use at your own risk. I usually powder the stone and drip enough water to make a watery paste then rub it around with my fingers and let it sit a couple minutes. Rinse and dry and they look nearly new again. Once again use at your own risk I have read it may release the bond from the plate to the diamonds but I have never had it happen to my plates. I also use those solid rubber blocks for cleaning sanding belts harbor freight sells them cheap and they last a long time.
-
AuthorPosts