Forum Replies Created
-
AuthorPosts
-
28 November 2012 at 8:39 pm #3972
I have the cheaper set that Highland Woodworking sells, the metric set. I really like them. They were very easy to get flattened on the back and sharpened. I have primarily used the 6mm and 10mm ones for mortise chopping and have had no issues. I run them over the strop 30 times when I’m done and have not yet had to resharpen them. I’ve used the 26mm one for some paring as well.
Rich;)
7 November 2012 at 3:49 pm #3010I’ve not gotten to use one extensively, but I tested out an Adria tenon saw at a demo and liked the feel of it. Pricewise, it’s between Veritas and LN or Bad Axe. Might be worth looking at.
http://adriatools.com/handsaw/small_tenon_saw.html
Rich;)
-
AuthorPosts