@jeztastic Active 3 months, 1 week ago Activity Profile Forums Topics Started Replies Created Engagements Favorites Search for: Search Forum Replies Created Author Posts Jez Downs 25 July 2020 at 10:27 pm #671304 Looks like birch to me, almost sure. That’s from the bark, but the wood looks diseased or rotten. Settings Jez Downs 15 June 2020 at 8:38 pm #665654 Good as new. Thanks for all the help. Settings Jez Downs 14 June 2020 at 7:35 pm #665513 Shim on the side for a tight fit, Titebond hide glue, and crossed fingers… Attachments:You must be logged in to view attached files. Settings Jez Downs 13 June 2020 at 2:30 pm #665356 Thanks for your advice. Yes, I suspect this has never been done before, it looks pristine. I’ll let you know how it goes. Settings Jez Downs 6 June 2020 at 11:23 am #664355 Got the handle out (it pretty much fell out) so need to clean and reglue. Is it meant to look so rough in there? Attachments:You must be logged in to view attached files. Settings Jez Downs 2 June 2020 at 10:09 pm #663906 The only stamp on the plane is the one in the picture I took behind the handle. From the look of your pictures I would say it’s the owner not the maker. Thanks for the advice regarding hide glue. I’ll look into it and post results. Settings Jez Downs 2 June 2020 at 7:44 pm #663869 No nail I can see. Is hide glue easy to come by? Plane has P. Everett on it. Don’t know if that would be a maker or an owner. The cracks look worse than they are I think they are superficial. Attachments:You must be logged in to view attached files. Settings Jez Downs 2 June 2020 at 7:42 pm #663866 No nail I can see. Is hide glue easy to come by? Plane has P. Everett on it. Don’t know if that would be a maker or an owner. Attachments:You must be logged in to view attached files. Settings Jez Downs 31 May 2020 at 9:51 pm #663602 I believe Paul has a cut list for the workbench on this website… This reply was modified 3 years, 11 months ago by Jez Downs. Settings Jez Downs 31 May 2020 at 1:07 pm #663471 Thanks. So, just pour some hot water on the joint and point a heat gun at it for a bit? Also, if it’s a rock-in fit, do I pull up the front or rear of the handle first? This reply was modified 3 years, 11 months ago by Jez Downs. Settings Author Posts