Reply To: My version of a work bench.
…French cleat on the back; 8) oil and wax; 9) mount and start using. Whew, hope I can complete this by the end of next weekend, I need to work…
…French cleat on the back; 8) oil and wax; 9) mount and start using. Whew, hope I can complete this by the end of next weekend, I need to work…
…own, is a 6″ Combination Square I bought from the local Target or K-mart, for AU$6. Don’t waste a lot of money on a tool you have to fettle yourself….
[postquote quote=786161] i fully understand what to mean, for this reason i was expecting to plow ‘from both side’. it would need to have parralelality between faces to ensure results…
…end I have been successful. So after all that rambling, if Paul says the next step in my training is a rocking chair, I’m in 100%. Cyber apprentice Greg Merritt…
…butt hinges from Niche Locks were good enough I think; perhaps not manufactured to the same finish, but then again they’re priced at 1/3 of the Brusso ones. https://www.nichelocks.com/Cabinet-Hardware/Cabinet-Hinges?zenid=8137219b4968b42259bb7870c4568c2c /soj…
…completely whilst doing that (and it looks as though it might) just glue, refit, and clamp as normal. A wooden dowell could add some strength, but drilling & screwing would…
…plane (No 4) Jack Plane (No 5) (optional as used while thicknessing) Tenon saw No 80 Cabinet scraper Card scraper Thickness planing jig (https://woodworkingmasterclasses.com/2014/05/thickness-planing/) Shooting Board (https://woodworkingmasterclasses.com/2012/11/shooting-board/) * = optional…
…every 90 hours of woodworking (not that that’s an especially comparable number), so they seem to take more abuse than traditional soft water stones. Even though they are harder, you…
…be safely submerged, and reducing any leverage available against the particle. Lastly, O1 has carbides, too. That manganese in Hock’s O1? Yup, manganese carbide. So O1 has these issues, too,…
That’s a common problem with these vises. I know it has come up in a discussion before. It happens with mine as well. I think the solution is to back…