Tool Chest: Episode 13
In the episode, Paul shows how to fit and recess the hinges on the box. He tells us what to look out for when using brass hinges, and how to line up the top and bottom of the box when fitting them.
In the episode, Paul shows how to fit and recess the hinges on the box. He tells us what to look out for when using brass hinges, and how to line up the top and bottom of the box when fitting them.
In this episode, Paul shows us how to accurately saw our boxes into two sections. He then shows us how to plane the edges of the top and bottom so that the chest will close snuggly. Difficult grain? See several ways of dealing with it.
In this week’s episode, Paul shows how to glue on the top of the chest and glue and screw on the bottom, including how to recess the screws. He also shows what to do if we have twist or cupping in our chest.
In this episode, Paul shows how to pare down the corners and plane and scrape the outside of the box. He then planes the top and bottom edges to prepare them for the gluing on of the top and bottom frames. He finishes off by marking the box ready for sawing it into two parts.
In this episode, Paul finishes off the bottom frame. He removes the haunches, surface planes and scrapes the frame surfaces and creates the round overs on the edges. This process is the same for the top frame.
In this episode Paul assembles the top frame with it’s two raised panels and shares some tips on safe assembly. Paul also glues and clamps the assembly.
In this episode Paul shows how to use the smoothing plane to raise the solid wood panels to fit in the top frame of the chest. He introduces a few different approaches to make sure you get, crisp, mitred corners and an even chamfer.
In this episode Paul shows how to plane and scrape the frame and also cut plywood for the bottom of the cabinet (he will show an alternate solid wood method in a later episode). He will also show assembly and gluing up.
In this episode Paul shows how to continue to make the frame for the bottom of the chest. He shows how to make the tenons and fit the frame together. This is the first time that we have shown how to make mortise and tenon frames on Woodworking Masterclasses.
In this episode Paul shows how to layout and run grooves in the bottom frame. He also lays out the mortises and cuts the first mortises.